Generally speaking, linear guide rail is also called slide rail or linear slide rail. Of course, they are called linear guides directly. Why? In fact, it is suitable for linear reciprocating motion. It has high rated load index and can bear some loads.

Pay attention to 5 points when installing the linear guide rail:

1. Preparation before installation. We need to check the proper installation machinery to see if there is burr, scratch or even dirt on the installation surface. If we have, we have to clean up. We will brush a antirust brush on the diameter, so we will do this before installing it, and then install it. Before installation, lubricating oil must also be applied to the foundation surface to prevent rust.

2. The line guide must be placed on the ground. Generally speaking, we will not fully lock the assembly bolt, according to the linear guide Tensile Requirements and the installation surface smooth and tight. Here we must pay attention to the assembly of bolts must be clean. In addition, we should pay attention to the installation of bolts on the linear guide to ensure the coincidence of bolt holes. If it doesn't match, the accuracy will be reduced.

3. When tightening the conductor, pay attention to ensure that the track is close to the horizontal installation surface.

4。 It should be noted that the use of torque wrench is based on the operation process to tighten the assembly bolt torque. Attention should be paid to the sequence of bolts, i.e. from the center to the two shafts, so the operation accuracy is high.

5. Finish the installation of the remaining linear guide rail, and then put the hole into the assembly bolt hole, so that the hole cover and the top surface of the linear guide rail can be on the plane.

The above is a group of parts to summarize the precautions during the installation of linear guide rail. On this basis, we can get more stable and precise equipment. We know that when running a straight-line guide, it depends entirely on its stability and accuracy to achieve our goals. Therefore, we must be careful to complete the corresponding operations. We must also have certain operation specifications for each part of the conference, which also needs special attention.