The rack and pinion can not be installed blindly after production, but should be adjusted. First, check whether the gear and rack are assembled correctly. Then check whether the contact of the gear teeth deviates to one end. After operation, it needs constant debugging. Smooth operation. The third is to observe whether there is a proper side gap. Fourth, before operation, we need to lubricate the gear and rack. During installation, we can use small Ding to fix the rack. Next, Taiwan's t-win manufacturer will explain the matters needing attention for you.

1. In the combination of distributor drive and electric gear, the synchronization of rack drive is realized from the outside.

2. To check that the tooth contact is deflected to one end. After operation, it needs constant debugging. Smooth operation.

3. Fasten the first rack with the fastening bolt with the strength of grade 12 according to the corresponding pre tightening force.

4. Fasten the second rack according to the pre tightening force, and install the subsequent rack according to this method.

5. In this case, it is recommended to use flange clamp: position and fix the rack (for example, use screw clamp to press against the mounting surface).

6. Before operation, we need to lubricate the gear and rack. Rack and pinion can not be put into use immediately after installation, we need to adjust them first.

The above are the six items that need attention. If you have any other questions, please contact our factory.