After the production of gears and racks, they should not be blindly installed, but adjusted. First, check if the assembly of the gears and racks is correct. Then check if the tooth contact is biased towards one end. Continuous debugging is necessary after operation. Smooth operation. The third is to observe whether there is an appropriate side gap. Fourthly, before operation, we need to lubricate the gears and racks. During installation, we can use Xiaoding to fix the rack. Below, Taiwanese T-win manufacturers will explain to you the precautions that need to be taken.

Gear and rack

1. The distributor transmission device achieves synchronization of the rack and pinion transmission device from the outside in combination with the electric gear.

2. Check if the tooth contact is biased towards one end. Continuous debugging is necessary after operation. Smooth operation.

3. Tighten the first gear rack with a grade 12 fastening bolt according to the corresponding pre tightening force.

4. Tighten the second rack according to the preload force and install the subsequent racks using this method.

5. In this situation, it is recommended to use a clamp to position and fix the rack (such as using a spiral clamp to press against the mounting surface).

6. Before operation, we need to lubricate the gears and racks. The rack and gear cannot be put into use immediately after installation, we need to adjust them first.

The above are the 6 things to pay attention to. If you have any other questions, please contact our manufacturer.