What should be noted when installing gears and racks? Below, gear and rack manufacturers have shared the following content, hoping to help everyone!

1. When unpacking and handling racks, it is necessary to wear a safety helmet, goggles, protective gloves, and safety shoes.

2. The edges of the gear rack, especially the helical gear rack, are very sharp, and direct contact with the gear rack requires wearing gloves.

3. Do not touch the gear rack without wearing gloves. Please wash your hands after installation and assembly work, as the surface of the product is coated with rust proof oil.

4. The transportation of the rack must be appropriately protected, and if necessary, clear markings should be made at the end of the product to distinguish it.

5. To avoid personal injury caused by bending deformation and incorrect posture of the rack, if the length exceeds 1 meter, two people must cooperate in unpacking and handling.

6. If the weight exceeds 8 kilograms, cooperation between two people or a crane is necessary, and the crane driver must have relevant qualifications.

7

Skilled personnel with relevant experience and knowledge are required to operate the assembly and installation of gear racks.

8. When placing the rack, consider the center of gravity of the product, otherwise it may cause the machine to tilt or the rack to slip. The consequence is limb injuries. Additional support arms can be considered in the product placement area to prevent the tabletop from bending.

9. To avoid injury, the height of the installation platform must be suitable for the operator's height. We need a height adjustable installation platform to accommodate operators of different heights.

10. A suitable height assembly worker makes it easier to assemble bolts. In addition, selecting a suitable wrench can protect the assembler's wrist from impact. Preparation for these work environments is necessary to avoid injuries during work.

11. To prevent hands and fingers from being squeezed or scratched during the placement of the rack, it is necessary to provide a suitable bracket on the installation platform.

12. If the rack is less than 1 meter, it must be fixed with a pin and then locked with a bolt.

13. If the rack is installed in a straight line, it must be ensured that the pitch line of the rack is within the allowable error, and the joint points are also the same.

The above are precautions for installing gears and racks, for your reference only. If you have any other questions, please contact us promptly!